OPERATING SECTION 4 Page 9 4.4. CAB CONTROLS Fig. 4.3. Air Conditioner, Heater and Accessories Controls 1. Door Wiper Switch and Washer Push-button 2. Window Wiper Switch and Washer Push-button 3. Heater and/or Cooler Pressurized Control Switch 4. Temperature Control Knob DOME LIGHT Dome light is switched on with switch mounted in the light. CAB VENTILATION NOTE: For maximum cooling turn the temperature control knob fully to the left. 1. DOOR WIPER SWITCH This switch activates window wipers and washers. Principle of operation is similar to wiper timing switch and washer. 2. WINDOW WIPER SWITCH This switch activates window wipers and washers.
The switch enables two-speed selection of the wipers, low and high speed when turn to the left and push the washer button to spray washer fluid. 3. HEATER AND/OR COOLING PRESSURIZER FAN SPEED CONTROL SWITCH This switch controls the speed of the fan circulating air inside the cab. It has three speed settings low, medium and high. Turn the knob to the left for three fan speed selections when cooling the air, i.e. low, medium and high. Turn the knob to right for three fan speed selections when heating air i.e. low, medium and high. To turn the fan off, turn knob to center position. 4. TEMPERATURE CONTROL KNOB This knob is used to control temperature inside the cab.
To decrease temperature turn the knob to the left position and to increase temperature turn the knob to the right position. DRESSTA TD-20H