OPERATING SECTION 4 Page 27 4.17. OPERATING MOUNTED EQUIPMENT 4.17.4. FLOAT With the control lever in the float position, the blade is free to follow the contour of the ground. To place the control lever in the float position, push all the way forward to its detented position in direction I in Fig. 4.25. The lever will remain in this position until it is manually returned to the hold position. 4.17.5. TILT LH TILT Pull the control lever to the left to lower the left hand corner of the blade. The lever will return to the hold position when released. RH TILT Push the control lever to the right to lower the right hand corner of the blade.
The lever will return to the hold position when released. 4.17.6. RIPPER CONTROL LEVER NOTE: For proper operation of ripper control lever and observation of working tool it is necessary to swivel the operator’s seat 15° to the right. Fig. 4.25. Ripper Control Lever 1. Blade Control Lever 2. Ripper Control Lever I. Ripper Pitch Forward II. Ripper Pitch Aft III. Ripper Raise IV. Ripper Lower V. Hold 1. Ripper Pitch (forward or aft) To change angle of ripper tooth move the ripper control lever: a) Ripper point forward – move the lever to “I” position. b) Ripper point aft – move the lever to “II” position. DRESSTA TD-20H