OPERATING SECTION 4 Page 29 4.17. OPERATING MOUNTED EQUIPMENT a) hold the tilt control lever in the tilt position until the piston rod in the tilt cylinder is either fully extended or retracted (depending upon the side to be tilted). Shut off the engine. Refer to „STOPPING THE ENGINE”. b) Adjust the mechanical strut as described under „TILTING THE BLADE (MECHANICAL TILT)”. LEVELLING THE BLADE WITH HYDRAULIC TILT 1. Place the lowest corner of the blade on a flat surface. 2. Hold the control lever in position on this side to which the blade is to be lowered until the blade is even along the flat surface. PITCHING THE BLADE (FIG. 4.27) Fig. 4.27. Blade Pitch 1.
Decreased suction angle for soft material. 2. Increased suction angle for hard materials. 3. Upper strut. 1. To pitch the blade forward (increasing the suction angle), raise the blade several centimeters off the ground. Shut off the engine. Refer to „STOPPING THE ENGINE”. Then extend the upper struts (3) on each side of the blade an equal amount in the range of dimensions A given on Fig. 4.28. Fig. 4.28. Upper strut adjustment A = 1332 - Fully shortened A = 1434 - Fully extended IMPORTANT: Do not expose any portion of the eyebolt threads. DRESSTA TD-20H