OPERATING SECTION 4 Page 31 4.17. OPERATING MOUNTED EQUIPMENT Install the mounting pin aligning the lock holes and secure with locking hardware. Retorque the strut eyebolt clamping cap screws and nuts to 450 Nm. 9. Level the blade so one end does not dig in deeper than the other. This can be done by adjusting either or both upper struts. Refer to „LEVELLING THE BLADE” Fig. 4.30. Lower Strut Adjustment of the Angled Blade. 1. Trunnion Swivel Eye 2. Gap Fig. 4.31. Lower Strut Adjustment Gap. 1. C-frame 2. Swivel Pin 3. Gap TILTING THE BLADE (MECHANICAL TILT, FIG. 4.26) 1. Raise the blade 300 mm above the ground and shut off the engine. Refer to „STOPPING THE ENGINE”. 2.
Remove the strut trunnion from its bracket on the side to be raised, and position strut close to the C-frame. 3. Adjust the opposite side to get the desired tilt by shortening the upper strut. Adjust this strut to tilt the blade about half of the desired tilt. WARNING! Always lower the side being adjusted first so lack of balance will not cause the loose strut assembly to swing out and cause unexpected injury or damage. 4. Return to the side of the machine on which the strut assembly was disengaged, and lengthen the upper strut until the strut trunnion can be inserted in its bracket on the C-frame. DRESSTA TD-20H