DRESSTA TD20H98/1E — 4.18. OPERATING TECHNIQUES

SECTION 4 OPERATING Page 32 4.17. OPERATING MOUNTED EQUIPMENT NOTE: Do not tilt the blade more than 480 mm tip to tip. 5. After tilting the blade, raise the blade above the ground 300 mm and shut off the engine. Refer to „STOPPING THE ENGINE”. Adjust the upper struts to a „neutral” position (no compression or tension) so the blade connecting pins are free in their brackets. 6. Whenever the blade is tilted, adjustments to one upper strut must always be equal and opposite to the adjustment made on the other strut. (For example: if a strut on one side is shortened 1 1 / 2 turns, lengthen the opposite strut 1 1 / 2 turns). LEVELLING THE BLADE WITH MECHANICAL TILT (Fig. 4.32) 1.

Lift the blade off the ground and shut off the engine. Refer to „STOPPING THE ENGINE”. 2. Remove the locking pins and adjust both upper struts to the gap between the shoulder of the eyebolts (1 and 4) and the strut body, is 39 mm on each end. This will position the blade in its neutral pitch position. If the blade is not level, a half turn of the upper strut in either direction will level the blade. 3. After leveling the blade, raise the blade above the ground 300 mm and shut off the engine. Refer to „STOPPING THE ENGINE”. Adjust the upper struts to a „neutral” position (no compression or tension) so the blade connecting pins are free to revolve in their brackets. Fig. 4.32.

Upper Strut Adjustment of Angle Blade. 1. Eyebolt 2. Strut Body 3. Locking Pin 4. Eyebolt 4. Having determined the „neutral” position, shorten each upper strut by 1 full turn. IMPORTANT: Adjustment made in step 4 must be made only if all strut adjustments have been made with blade raised off the ground. 5. Reinstall the upper strut locking pins. 4.18. OPERATING TECHNIQUES WARNING! Before operating the machine, be sure the area of the operator's compartment, all mounting steps and grab handles are free of oil, grease, loose objects, ice, snow and mud to lessen the possibility of slipping.

Remove or secure all maintenance and personal items so they will not interfere with the operator or jam the controls. Failure to follow these instructions may result in serious injury. TD-20H DRESSTA