DRESSTA TD20H98/1E — 4.18.1 DIGGING AND CLEARING

OPERATING SECTION 4 Page 33 4.18. OPERATING TECHNIQUES When the blade is held hydraulically it becomes a rigid part of the tractor, except when the valve is in “FLOAT” position, and will follow all movements of the machine. When rough terrain encountered it will be necessary to vary the height of the blade while pitching to obtain a smooth cut. When possible, start all jobs from relatively level ground. If necessary, level an area large enough to provide sufficient working space for the machine. This prevents back and forth pitch of the machine and will result in easier digging.

Avoid track spinning whenever possible; this wastes effort and converts a relatively smooth working area into ruts and piles that pitch and tilt a tractor. In cold weather this material can freeze and cause additional difficulty the following day. Crossing ditches, ridges, rock or logs should be done slowly and, at an angle. This slows the fall, lessens the danger of upsetting the machine and reduces the fall jolt, which can be harmful to the operator and machine. 4.18.1. DIGGING AND CLEARING WARNING! Prior to operating know the locations of gas lines, utility lines, sewers, overhead and buried power lines, and the other obstructions or hazards are known.

A raptured gas line or cut electrical line could result in personal injury. Always feed the blade into the ground gradually until the desired depth of cut is obtained. When selecting the gear range and determining the depth of cut, allow for an increase in resistance as the load increases. When raising the blade at the end of a cut, do it gradually to avoid an abrupt ridge or bump in the path of the tractor. Move material downgrade whenever possible to take advantage of the reduced effort required (Fig. 4.33). Fig. 4.33. Moving Material Downgrade Two methods of cutting down a pile or hill are shown in Fig. 4.34. Type of material and local conditions may dictate which method is preferred.

Further information is included in “BREAKING PILES AND SPREADING” When using Method l, never allow the high face to become a hazard to the operator or machine. With the tractor at right angles to the face, raise the blade and dislodge the high bank before returning to the original direction of cut. When using Method 2, make the cut wide enough to avoid trapping the tractor. WARNING! Avoid high overhangs. Ramp up and remove the top layers first. Avoid high banks. Operate the machines as far away from the trench as possible or cave-in may result. DRESSTA TD-20H