SECTION 4 OPERATING Page 38 4.18. OPERATING TECHNIQUES Fig. 4.45. Aiding Scraper Loading Fig. 4.46. Loading Directly The bulldozer can be used directly as a loader if the method shown in Fig. 4.46 is used. 4.18.3. BREAKING PILES AND SPREADING Two methods of breaking down a pile are shown in Fig. 4.47. When spreading is to be in several directions or if the pile is large or hard, Method 1 is usually desired. When using Method 1, cut into the side of the pile from different angles. When Method 2 is used, and access to the top of the pile is difficult, a slot may be started as shown below. Loosen material at the base and form a dirt “ramp” to provide a decreased angle of approach and cut. Fig.
4.47. Breaking Down a Pile Method 1 Method 2 1. Ramp 2. Original Slope When trucks or wagons are used for hauling, bulldozers are ideal spreading tools at the fill (Fig. 4.48). Blade should be kept in a straight position so that material is drifted directly under the cutting edge (Fig. 4.49). When finishing in non-solid materials, such as earth, drag the blade backward for a smooth job as shown in Fig. 4.49. Rock, of course, may damage the blade base, therefore, such practice is not recommended where abrasive material is common. TD-20H DRESSTA