DRESSTA TD20H98/1E — 5.5.2. COOLING SYSTEM

SECTION 5 MAINTENANCE Page 14 5.5. SEASONAL PREPARATION General Mechanical efficiency is enhanced during seasonal air temperature changes, when these instructions are followed. Outside source of heat Machines left outside for prolonged periods in sub-zero weather will suffer from "cold-soak." Lubricants become viscous and incapable of lubricating moving parts. Extreme wear could result to the engine, transmission and final drives unless proper precautions are taken. A source of outside heat is necessary under these conditions. There are electric as well as propane-fired engine coolant heaters available.

Gas-fired forced air heaters may also be obtained to heat the transmission and final drives. When using such heaters follow manufacturer’s safety instructions. WARNING! For your personal safety, use caution and follow the manufacturer's instructions when using engine block heaters to warm the coolant or external heaters to warm the tractor. 5.5.1. FUEL SYSTEM Refer to "FUEL SYSTEM" for the diesel fuels selection, which will give the most satisfactory performance. 5.5.2. COOLING SYSTEM Prepare the cooling system as follows: 1. Check the entire engine system for leaks. 2. Inspect the condition of all hoses and replace the hose and hose clamps as necessary. 3. Clean cooling system.

Refer to „CLEANING THE SYSTEM.” 4. Check the drive belt tension and adjust tension or replace belt. Refer to „ENGINE MANUAL”. 5. Remove all debris from the radiator core using air or water under pressure. Direct the flow through the core, opposite the normal direction of air flow. WARNING! For your personal protection, water pressure should not exceed 275 kPa and air pressure should not exceed 210 kPa. Use safety goggles. 6. Clean the radiator guard and outside of the core. 7. Protect your cooling system from damage by using approved antifreeze and coolant. Refer to „FILLING THE DRAINED SYSTEM”. 8.

Keep your cooling system clean and minimize corrosion by changing the coolant filter at correct intervals. Refer to „COOLING SYSTEM.” 9. Check the condition of fan blades. TD-20H DRESSTA