DRESSTA TD20H98/1E — 5.6.2. PRIMARY FILTER ELEMENT

MAINTENANCE SECTION 5 Page 15 5.5. SEASONAL PREPARATION 5.5.3. ELECTRICAL SYSTEM Clean batteries and remove all corrosion from the battery terminals and cables. Repair or replace all wires, which have worn, cracked or frayed insulation and broken or loose wires. Service the batteries. 5.6. AIR CLEANING SYSTEM 5.6.1. AIR CLEANER This machine has a „dry-type” cleaner with replaceable elements. The cleaner has two elements: primary and safety. The primary can be cleaned for a limited number of times before replacement is necessary, however, the safety element must be replaced when plugged. Detailed service procedures for this air cleaner are covered in the following text. IMPORTANT:

As a precaution against dirt entering the engine, all gasket and rubber hoses between the air cleaner, turbocharger and intake manifold, and between the manifold and cylinder head must be in good condition and the joints or connections must be tight. Never operate the engine unless a filter element is in place and filter end gasket is installed. Never remove the element from the air cleaner or service the air cleaner while the engine is running. 5.6.2. PRIMARY FILTER ELEMENT Service The air cleaner primary element must be serviced whenever indicated by the air cleaner filter warning light. Refer to "AIR CLEANER FILTER WARNING LIGHT".

If after performed cleaning of primary filter element the air cleaner filter-warning light continues to glow, check for allowable restriction, precleaner screen. If the warning continues to glow replace safety filter element. If with cleaned primary filter element and replaced safety filter element the warning light still continues to glow, check air cleaner service indicator. The primary element can be cleaned by either of two methods: washing or compressed air. Washing is the preferred method as it removes more dust and soot and restore the element to an almost new condition. The result being better performance and longer intervals between required element service.

It is recommended that a spare element be obtained for use while the serviced element is drying. NOTE: The primary filter element must be replaced after six washing. Cleaning the element with compressed air is not considered an entirely satisfactory method. Some dust will remain in the element causing more frequent servicing of the element. Cleaning with compressed air should be used only as a temporary measure until sufficient time is available to clean the element by washing. Engine air intake system (hoses, clamps, rubber connectors) is recommended to be checked for leaks ever 50 hours of operation. NOTE:

After cleaning, if an element is to be stored for later use, place it in a plastic bag and store in an element-shipping container to protect against dirt and damage. DRESSTA TD-20H