SECTION 5 MAINTENANCE Page 16 5.6. AIR CLEANING SYSTEM Removal (Fig. 5.2) 1. Stop the engine. Lower equipment on the ground. Open left engine access door. Remove all dust from the element removal end of the air cleaner body (8) 2. Release two lock clamps (1) and remove cover (2) from the air cleaner body (8), 3. Unscrew the wing nut (4) remove gasket (3) and carefully remove the primary element from the body not to dislodge dust from the dirty element onto the safety element (7). 4. Check the condition of the gasket on the end of the primary element (5). If the gasket is damaged or missing, replace the primary element. 5. Remove all dirt from inside the air cleaner body with a damp cloth.
A small amount of nonsudsing detergent added to the water will remove the soot. Fig. 5.2. Air Cleaner with Connections 1. Clamp 2. Cover 3. Gasket 4. Wing nut 5. Primary Element 6. Wing nut 7. Safety Element 8. Filter Body 9. Air Filter Assembly 10. Clamp 11. Elbow 12. Tube 13. Clamp 14. Body of Primary Filter 15. Cover of Primary Filter 16. Clamp 17. Elbow 18. Clamp 19. Pressure switch Washing IMPORTANT: Never wash element in fuel, oil, gas or solvent. DO NOT OIL ELEMENTS. Do not tap the element against a hard surface; this will damage the element. TD-20H DRESSTA