DRESSTA TD20H98/1E — 5.7. BELTS

MAINTENANCE SECTION 5 Page 19 5.6. AIR CLEANING SYSTEM 4. Check if underpressure of 0.14 – 0.21 kG/cm 2 has been obtained by reading the pressure. If improper pressure is seen, adjust pressure to 0.14 – 0.21 kG/cm 2 by cranking the engine crankshaft to a position where minimum leakage occurs past engine valves. 5. Coat the following areas with soap solution and check for leaks. Leaks will cause air bubbles to form. a) air cleaner body surface around the outlet pipe to app.

the outside diameter of safety element b) air cleaner outlet to turbocharger inlet hose to air cleaner body junction orifice and tubing from the air cleaner c) all clamped hose and gasket connections between air cleaner outlet and intake manifold. This includes connections at turbocharger d) surface of all air induction piping and hoses air cleaner and air intake manifold including the manifold gasket area and warning light switch connector. 6. No leakage is permitted between air cleaner and intake manifold (the entire air induction system). IMPORTANT: Tightness of the air intake system has a great influence to the engine durability. 5.7. BELTS General WARNING!

Keep clear of fan and fan belts when the engine is running. Rotating fan and belt contact can cause injury. Fig. 5.4. Belt Inspection Replace badly worn, greasy or cracked belts immediately. These conditions prevent proper belt function. Visually inspect the drive belts for intersecting cracks. Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable. Replace the belt if it is frayed or has pieces of material missing. DRESSTA TD-20H