130202. ciently Illustration Illustration Maintenance work: Hydraulic oil change at intervals of 2 000 operating hours (i.e. if you need to change the type of oil) i NOTE! Take the compaction roller to a workshop in order to carry out the oil change. WARNING! Environmental protection! The hydraulic oil must not penetrate the ground, pollute water or leak into the sewer system. Collect it in sufficiently dimensioned receptacles. Dispose of it in accordance with EU waste disposal key 130202. • Start the Diesel engine and let it run until the hydraulic oil has warmed up. • Stop the Diesel engine and remove the ignition key. • Place an oilpan under the hydraulic tank.
• Unscrew the oil filler neck with the oil dipstick. i NOTE! Be sure to take the amount of hydraulic oil to be drained into account and to use a sufficiently dimensioned oilpan to collect the leaking oil. • Screw off the oil drain plug. Remove the oil dipstick and drain the hydraulic oil. • Dispose of the waste oil in accordance with EU waste disposal key 130202. • Replace the oil filter cartridge, see instructions above. • Fit the oil drain plug with a new O-ring and screw it in. • Add hydraulic oil via the filter. CAUTION! Be sure to exercise extreme cleanliness when fi lling in hydraulic oil! Inform yourself of the type of hydraulic oil in the hydraulic system, see Table of lubricants.
• Add hydraulic oil via the oil filler neck. • Start the Diesel engine and let it run until the hydraulic oil has warmed up. • Stop the Diesel engine and pull out the ignition key. • Check the hydraulic oil level again.