. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 166 BEFORE STORA GE g-term storage (more than one month), store as follows. When keeping in lon g-term storage (more than one month Clean and wash al l parts, then store the machine indoor s. If the machine has t o be store d outdoors, s elect level ground and cover the machine with a sheet. m collecting. n rod with grease. Completely fill the fuel tank. This prevents moisture fro Lubricate and cha nge the oil before storage. Coat the exposed portion of the hydraulic cylinder pisto Disconnect the ne gative terminals of the battery and cove r it or remove it from th e machine and s tore it s eparately.
Set the lock lever to the LOCK position to prevent the m achine from moving. gine coolant. To prevent rust, fil l with COOLANT to give a density of at least 30% for the en gine coolant. If it is necessary to perf orm the rust-prevention operation while th e machine is indoors, ope n the door s and windows to improve ventilation and prevent gas poisoning. During storage, op erate and move the machine for a sho rt distance once a mon th so that a new film of o il will coat moving parts. At t he same time, also charge the batter y. ase from the hydraulic cylinder rods.
When operating th e work equipment, wipe off all the gre ase from the hydraulic cylinder r If the machine is e quipped with an air conditioner, opera te the air conditioner fo r 3 to 5 m inute s once a month to lubricateall parts o check the refrigera f the air conditionercompressor. Alwa ys run the engine at low idle when doin g this. I n addition, nt level twice a year. NOTICE If the machine has bee n stored without carrying out the monthly rust-prevention operatio n, consult your Komatsu distributor before using it. When using the mac hine after long-term storage, do as fol lows before using it. Wipe off the greas e from the hydraulic cylinder rods. at all lubrication points.
Add oil and grease When the machine is stored for a long period, moisture in the air will mix with the oil. Check the o il befor e and after starting the engine . If there is water in the oil, change a ll the oil. abnormality in the belt. he pulley, remove it with a wire brush. Check that there i s no rust on the engine pulley and no abnormality in the belt If there is excessiv e rust on the belt contact surface of t he pulley, remove it wi th a wire b rush.