Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST CHECKING The standard deflection between the air conditioner compressor pulley and crank pulley when pressed with a thumb (approx. 98 N (10 kg)) should be approx. 11 to 15 mm (0.4 to 0.6 in). When a belt tension gauge is used, the standard tension is within a range of 353 to 530 N (36 to 54 kg). 1. Loosen bolt (1), then loosen the locknut of bolt (2), tighten bolt (2), and move compressor (3) to adjust. 2. Tighten bolt (1) and the locknut of bolt (2) to hold the compressor (3) in position. NOTICE Check each pulley for damage, wear of the V-groove, and wear of the V-belt.

In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 4 - 44 CHECK WHEN CHANGING TH E V-BELT The standard deflection be tween the air conditioner compresso r pulley and fan pulley when pressed with a thumb (approx. 98 N (10 kg)) sho uld be approx. 8 to 11.5 mm (0.315 t o 0. 5 in). (54 to 76 kg). When a belt tension gaug e is used, the standard tension is wit hin a range of 530 to 745 N REMARK When the belt has been re placed with a new part, a high tensio n is necessary, so the initia l tension is in the value given above.

ADJUSTING In case any of the following occurs, ask the Komatsu distributor in y territory to replace the belt • The fan belt has elongat • A cut or crack is found o • Slipping or creaking sou s with new ones. ed, leaving little allowance for adjustmen n the belt. nd is heard coming from the belt. , readjust it after one hour of operation. nd is heard coming from the belt. When the new V-belt is set