. MAINTENANCE SERVICE PROCEDURE 4 - 43 WHEN IT IS IMPOSSIBLE TO CHECK ELECTROLYTE LEVEL FROM SIDE OF BATTERY If it is impossible to check the electrolyte level from the side of the battery, or there is no display of the UPPER LEVEL line on the side of the battery, check as follows. 1. Open the cover of the battery box. There are two battery boxes: One on each side at the rear of the machine. 2. Remove cap (1) at the top of the battery, look through the water filler port (2), and check the electrolyte surface. If the electrolyte does not reach the sleeve (3), add distilled water so that the level reaches the bottom of the sleeve (UPPER LEVEL line) without fail. (A) Suitable level:
Electrolyte level is up to bottom of sleeve, so surface tension causes electrolyte surface to bulge and poles appear bent. (B) Low: Electrolyte level is not up to bottom of sleeve, so poles appear straight and not bent. 3. If distilled water has been added to any cell of cap (1), add distilled water also to the other cells. 4. After adding distilled water, tighten cap (1) securely. REMARK If distilled water is added to above the bottom of the sleeve, use a syringe to lower the level to the bottom of the sleeve. Neutralize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your Komatsu distributor or battery maker.
REMARK If distille syringe remove to lower the level to the bott d fluid with baking soda (so om of the sleeve. Neutralize th dium bicarbonate), then flush away w ith a large amount of w or or battery maker. distribut If it is im possible to check the ele LEVEL l ine on the side of the batt 1. Ope n the cover of the battery The re are two battery boxes: One on each side at the rear o 2. Remove cap (1) at the top of th e battery, look through the wat filler port (2), and check th e electrolyte surface. If th electrolyte does not reach the sleeve (3), add distilled water s that the level reaches the botto m of the sleeve (UPPER LEVE line) without fail. (A ) Suitable level:
Electrolyt e level is up to bottom of sleev ce tension causes electroly o bulge and poles appear ben (B ) Low: Electrolyte level is 3. distilled water also to the other 4. Afte r adding distilled water, tig WHEN IT IS POSSIBLE TO USE INDICATOR TO CHECK ELECTROLYTE LEVEL If it is po ssible to use an indicator to check the electrolyte level, follow the instructions given CHECK PARKING BRAKE 1. Stop the machine on a dry parking brake switch to the ON brake holds the machine in tha 2. If any problem is found, p distributor. slope (downhill slope), set th 1. 2. 1. Stop parking brake switch to the ON position (A), and check that th brak e holds the machine in tha t position.
lease contact your Komats If any problem is found, p distributor.