. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL PRE-FILTER CARTRIDGE WARNING becoming dirty. 4 - 49 After the engi ne has been operated, al l parts are at high t emperature, s o do not replace the filter im mediately. Wait for a ll parts to cool down before starting the oper High pressur e is generated inside the engine fuel pipin g system when When replaci ng the filter, wait for at l east 30 seconds a fter stopping the engine to let the interna l pressure go down before replacing the Do not bring NOTICE Genuine Kom atsu fuel filter cartridge s use a special fil ter that has hi ghly efficient filtering ability . When replacing th e filter cartridge, alw ays use a genuine Koma tsu part.
The common rail fuel injection system used on this ma chine consists of more precise parts than the conventional in jection pump and no zzle. If any part ot her than a genuine Komat su filter cartridge is used, dust o r dirt may get in and cause problems with the in jection system. Alw ays avoid using substitut e parts. When carryin g out inspection or main tenance of the fue l system, pay more attention than normal t o the entry of dirt. I f dirt is stuck to any part, use fuel to wash it o ff completely. Prepare a fi 1. Open the engine side cover on t he right side of t he chassis. 2. The fuel p re-filter forms one unit with the water s eparator and is at the rear of the engi 3.
Remove c onnector (1). ving the connector, c l bag or tape to protec t them and prev ent them from 4. Set the co ntainer to catch the fu el under the filte