Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE cup (3) installed to the bottom of the plug (4) at the bottom of cup (3) of the fuel Cap (A) acts to prevent the entry of dirt or dust into the filter cartridge. 4 - 50 5. Using a filter wrenc on remove it. 6. Take water separa 7. cartridge and turn i again. If it is dama Install cup (3) to th When doing this, a Tightening torque f When replacing th before installing it. 8. Check that drain p pre-filter is tightene Tightening torque: 9. Clean the filter hol NOTICE When filling the filter cartr cap Cap (A) fitted. (A) acts to prevent th 10. Fill the filter cartrid 11. (B) in the new filter Coat the packing s 12.

Remove filter cartri dge cap (A) and install to the filter holder. 13. When installing, tig hten until the packing surface contacts the seal surface of the fil ter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will l ead to leakage of fuel. If the filter cartridge is to o loose, fuel will also leak from the packing, so always tighten t When tightening with a filter wrench, be extremely careful not to dent or damag 14. Connect connector 15. When carrying out standard replacement of the fuel filter cartridge (EVERY 1000 HO URS), replace the cartlidge and bleed the air.

F or details, see "REPLACE FUEL MAIN FILTER CARTRIDGE (PAGE 4-52)". 16. Start the engine, c heck that there is no leakage of fuel from the filter seal surface o r water separator mounting surface, then run f or approx. 10 minutes at low idling.