. MAINTENANCE SERVICE PROCEDURE it. PROCEDURE FOR BLEEDING AIR forward 4. After bleeding air, push in and tighten knob (1). 4 - 53 7. When installi ng, tighten until the pa cking surface contac ts the sea l surface of the filter holder, then tighten it 3/4 of a turn. If the filter ca rtridge is tightened too far, the packing wil l be damaged and this will lea d to leakage of fuel. If the filter cartridg e is too loose, fuel will also leak from the p acking, so always tighten the 8. After comple ting replacement of fu el filter cartridge (1), bleed the air from the system For details, s ee "PROCEDURE FO R BLEEDING AIR ( PAGE 4-53)". 9.
After comple ting the air bleeding, s tart the engine and c heck that there is no leakage of fuel from the filter seal surface. If th ere is any leakage, ch eck the tightening co ndition of t he filter cartridge. If there is still fuel leakage, repeat Steps 1 - 3 to remove the filt er cartridge, then ch eck the packing surface for d amage or embedded dirt. If any damag e or embedded dirt is f ound, replace the c artridge with a new part and re peat Steps 4 - 8 to install 1. Fill the fuel t 2. Open the en gine side cover on the right side of the cha 3. Loosen and pull out feed pump knob (1) and move it f rd. on the side surface of the fuel pre-filter hea o be removed.