REFERENCE ONLY g N (f) I- S55.0MLM,P ·19·07JUN91 140497 PN=51 Lubrication and Maintenance/250 Hour SERVICE BATTERY A CAUTION: Battery gas can explode. Keep sparks and flames away from batteries. Use a flashlight to check battery electrolyte level. Never check battery charge by placing a metal object across the posts. Use a voltmeter or hydrometer. Always remove grounded (-) battery clamp first and replace it last. 1. On regular batteries, check electrolyte level. Fill each cell to bottom of filler neck with distilled water. NOTE: Low-maintenance or maintenance-free batteries should require little additional service.
However, electrolyte level can be checked by cutting the center section of decal on dash-line, and removing cell plugs. If necessary, add clean, soft water to bring level to bottom of filler neck. 2. Keep batteries clean by wiping them with a damp cloth. Keep all connections clean and tight. Remove any corrosion, and wash terminals with a solution of 1 part baking soda and 4 parts water. Tighten all connections securely. 3. Keep battery fully charged, especially during cold weather. If a battery charger is used, turn charger off before connecting charger to battery(ies). Attach POSITIVE (+) battery charger lead to POSITIVE (+) battery post.
Then attach NEGATIVE (-) battery charger lead to a good ground. 43 In freezing weather, run engine at least 30 minutes to assure thorough mixing after adding water to battery. NOTE: Coat battery terminals and connectors with a mixture of petroleum jelly and baking soda to retard corrosion.