REFERENCE ONLY RG.FANAL l .A -19-11 AUG94 A-Tension Tester B-Straightedge C-Alternator Bracket Cap Screw D-Nut on Mounting Bolt Lubrication and Maintenance/250 Hour Low belt tension causes slippage resulting in excessive cover wear, burn spots, overheating, or "slip and grab", causing belt breakage. High belt tension causes belt heating and excessive stretch, as well as damage to drive components such as pulleys and shafts. V-belts should ride on the sides of standard pulleys not on the bottom of the groove. NOTE: On engines with dual belts, check tension of front belt only. 2.
USing either JOG529 Tension Gauge (arrow) or belt tension tester (A) and straightedge (B), check tension of warm belts: • For Poly V-Belt, a 130 N (30 Ib force) applied halfway between pulleys should deflect belt by 13 mm (112 in.). 3. If adjustment is necessary, loosen alternator bracket cap screw (C) and nut (0) on mounting bolt. Pull alternator frame outward until belts are correctly tensioned. IMPORTANT: Do not pry against the alternator rear frame. Do not tighten or loosen belts while they are hot. Tension Used" Belt 378-423 N (85-94 Ib force) • Belts are considered used after 10 minutes of operation.
47 FAN AND ALTERNATOR BELTS TENSION OR REPLACEMENT Standard V-Belt tension can be checked with JOG529 Tension Gauge (arrow) or equivalent gauge. 1. Inspect belts for cracks, fraying, or stretched out areas. Replace if necessary. • For standard V-Belt, an 89 N (20 Ib force) applied halfway between pulleys should deflect belt by 19 mm (3/4 in.). 4. Tighten alternator bracket cap screw and nut firmly. 5. After a new or used belt has run for 10 minutes, recheck belt tension. 378--423 N (85-94 Ib force) Standard V-Belts Tension New Belt 578-622 N (130-140 Ib force) 423-467 N (95-104 Ib force) Single Belt Dual Belt