REFERENCE ONLY 140497 PN=54 Sll.0MLM.CXl ·19·09AUG94 4045 and 6068 Engines 4039 and 6059 Engines 3029 Engines Lubrication and Maintenance/250 Hour IMPORTANT: Filtration of oils is critical to proper lubrication. Always change filter regularly. Use filter meeting John Deere performance specifications. To determine the correct oil fill quantity for your engine, see ENGINE CRANKCASE OIL FILL QUANTITIES in the Specifications Section. 46 5. Remove oil filter packing and clean filter mounting pad. 6. Oil new packing and install new filter element. Hand tighten element according to values printed on filter element.
If values are not provided, tighten element approximately one turn after packing contacts filter housing. DO NOT overtighten filter element. 8. Fill engine crankcase with correct John Deere engine oil through rocker arm cover opening or on some engine applications, the timing gear cover opening. (See ENGINE OIL in Fuels, Lubricants, and Coolant Section for determining correct engine oil.) NOTE: Crankcase oil capacity may val}' slightly. ALWAYS fill crankcase to full mark or within crosshatch on dipstick, whichever is present. DO NOT overfill. IMPORTANT: Immediately after completing any oil change, crank engine for 30 seconds without permitting engine to start.
This will help insure adequate lubrication to engine components before engine starts. 10. Stop engine and check oil level after 10 minutes. Oil level reading should be on upper mark of dipstick. 7. Install drain plug with a new seal when equipped. 9. Start engine and run to check for possible leaks. 4. Remove and discard oil filter element (A).