REFERENCE ONLY a; N Ul I- Sll.0MLM.DVl -19-11AUG94 140497 PN=69 Lubrication and Maintenancel1200 Hr12- Yr FLUSH COOLING SYSTEM AND REPLACE THERMOSTATS A CAUTION: Explosive release of fluids from pressurized cooling system can cause serious burns. Shut off engine. Only remove filler cap when cool enough to touch with bare hands. Slowly loosen cap to first stop to relieve pressure before removing completely. 3. On left side of engine, open drain valve or remove drain plug (A) from engine block. Drain all coolant from engine block. 8. After cleaning the cooling system, fill with water to flush the system. Run the engine about 10 minutes, then drain out flushing water.
Fleetguarcf1J is a registered trademark of Cummins Engine Company. RESTORpM is a trademark of Fleetguard. 61 Drain old coolant, flush the entire cooling system, replace thermostats, and fill with recommended clean coolant. 1. Slowly open the engine cooling system filler cap or radiator cap to relieve pressure and allow coolant to drain faster. 2. Open radiator drain valve. Drain all coolant from radiator. 5. Fill the cooling system with clean water. Run the engine about 10 minutes to stir up possible rust or sediment. 6. Stop engine and immediately drain the water from system before rust and sediment settle. 7.
After draining water, close drain valves and fill the cooling system with clean water and TY15979 John Deere Heavy Duty Cooling System Cleaner or an equivalent cleaner such as FleetguarcJ® RESTORETM . 4. Close all drain valves after coolant has drained. Follow manufacturer's directions on label.