REFERENCE ONLY ~ ., (!) _ __ _ a: 140497 PN=70 S11,OMLM,DX1 ·19-1SNOV89 S11,OMLM, DY -19-09AUG94 Lubrication and Maintenancel1200 Hr12- Yr 13. Close all drain valves on the engine and the radiator. IMPORTANT: Air must be expelled from cooling system when system is refilled. Loosen temperature sending unit fitting at rear of cylinder head or plug in thermostat housing to allow air to escape when filling system. Retighten fitting or plug when all the air has been expelled. 14. Add coolant to radiator until coolant touches bottom of filler neck. (See RECOMMENDED ENGINE COOLANT in Fuels, Lubricants, and Coolant Section for determining appropriate coolant.) 62 9.
For thermostat replacement, remove cap screws and thermostat cover (A). 10. Remove and discard thermostats (A) and all gasket material (8). 12. Install new thermostats and cover. Tighten all cap screws to 27 N·m (20 Ib-ft). 15. Run engine until it reaches operating temperature. This mixes coolant and water uniformly and circulates it through the entire system. The normal engine coolant temperature range is 82°-94°C (180°-202°F). 16. After running engine, check coolant level and entire cooling system for leaks. NOTE: Some engines have only one thermostat. Illustration shows the two-thermostat engine. 11. Install new gasket.