REFERENCE ONLY '" 0> Z « ~ Z ~ CD '" '" ~ a: 1. Allow engine to cool, then carefully remove radiator cap. IMPORTANT: DO NOT apply excessive pressure to cooling system, doing so may damage radiator and hoses. 3. Connect gauge and adapter to radiator filler neck. Pressurize cooling system to 50 kPa (0.5 bar) (7 psi)*. If no leakage is detected, but the gauge indicated a drop in pressure, coolant may be leaking intemally within the system or at the block-to-head gasket. Have your servicing dealer or distributor correct this problem immediately. RG 1 8293.6 ·1 9·02AUG94 140497 PN=71 NOTE: Engine should be warmed up to test overall cooling system. 2.
Fill radiator with coolant to the normal operating level. 4. With pressure applied, check all cooling system hose connections, radiator, and overall engine for leaks. If leakage is detected, correct as necessary and pressure test system again. Test Cooling System: Lubrication and Maintenancel1200 Hr12-Yr PRESSURE TEST COOLING SYSTEM AND RADIATOR CAP 63 '" 0> Z « a N z ~ .... '" '" C!l a: "Test pressures recommended are for all Deere OEM cooling systems. On specific vehicle applications, test COOling system and pressure cap according to the recommended pressure for that vehicle. A CAUTION: Explosive release of fluids from pressurized cooling system can cause serious burns. Shut off engine.
Only remove filler cap when cool enough to touch with bare hands. Slowly loosen cap to first stop to relieve pressure before removing completely. 1. Remove radiator cap and attach to an approved tester as shown. 2. Pressurize cap to 50 kPa (0.5 bar) (7 psi)*. Gauge should hold pressure for 10 seconds within the normal range if cap is acceptable. If gauge does not hold pressure, replace radiator cap. 3. Remove the cap from gauge, turn it 180·, and retest cap. This will verify that the first measurement was accurate. Test Radiator Cap: