John Deere Series 300 (3029,4039,4045,6059,6068) — John Deere Series 300 (3029,4039,4045,6059,6068) User Manual

REFERENCE ONLY Sll,OMSE,A02 ·19·17FEB93 Sll,OMSE ,A03 ·19·17FEB93 140497 PN=75 Service/As Required i 5. Pump hand primer lever until fuel, without air bubbles, flows from fuel supply line connection. 9. While cranking engine with starting motor, loosen one fuel line connector slightly using two wrenches until fuel (free of air bubbles) flows from connector. Tighten connector while cranking engine. If engine still will not start, see your authorized servicing dealer or engine distributor. 67 6. Tighten supply line connector to 27 N·m (20 Ib-ft). 7. Leave hand primer in the inward position toward cylinder block. 10.

Repeat procedure for remaining injection nozzles until engine starts and air has been removed from fuel system. 4. Slightly loosen fuel supply line connector (A) at injection pump. 8. Move the speed control lever to slow idle. If the engine still will not start: If the engine will not start: