REFERENCE ONLY :8 u w o ~ Z =? 140497 PN=82 S11,OMSE,U ·19-09AUG94 -19-17FEB93 -19-26JUL93 S11,OMSE,AA S11,OMSE,W Service/As Required POWER TAKE-OFF (PTO) CLUTCH A CAUTION: Entanglement in rotating driveline can cause serious injury or death. Keep shield on PTO drive shaft (A) between the clutch housing and the engine driven equipment at all times during engine operation. Wear close fitting clothing. Stop the engine and be sure PTO driveline is stopped before making adjustments. The following instructions apply to engines equipped with a John Deere instrument panel. 1. Check the fuse (A) between the ammeter (8) and key switch (C) located on back side of instrument panel.
If defective replace with an MDL-25 fuse. 74 Proper performance of the power take-off unit will be related to the care it is given. Lubricate it periodically and keep the clutch properly adjusted. (See Lubrication and Maintenance/250 Hour Section.) 2. Check the fuse (A) mounted on the bottom of the magnetic safety switch. If defective, install an equivalent 14-amp fuse. If the power take-off does not work properly after adjustment and lubrication, contact your authorized servicing dealer or engine distributor. On North American Sourced Instrument (Gauge) Panels: CHECK FUSES