hitachi — Torque Converter Pressure(Inlet and Outlet)

OPERATIONAL PERFORMANCE TEST / Component Test TORQUE CONVERTER PRESSURE (INLET AND OUTLET) Summary: Measure inlet pressure and outlet pressure of the torque converter pressure at the port of torque converter housing. Preparation: 1. Stop the engine. 2. Inlet pressure: Remove the plug from the port of regulator valve (1). Install a hose, an adapter and a pressure gauge to the open part. Torque Converter : 6 mm Outlet pressure: Remove the plug from the port of torque converter housing (2). Install a hose, an adapter and a pressure gauge to the open part. : 6 mm 3. Start the engine. Check for any oil leaks at the pressure gauge connection. 4.

Maintain the torque converter oil temperature at 60 to 80 ° C (140 to 176 ° F). Measurement: CAUTION: Set the block onto the front and rear tires in order not to move the machine. Keep away from the machine. 1. Select the following switch positions: T4GB-04-05-024 T4GB-04-05-017 Block 2. Set the front/reverse lever to “F” (Forward) and the shift switch to “4” (Fourth Gear). Measure the pressure. 3. Repeat the measurement three times and calculate the average values. Evaluation: Refer to the Performance Standard Table in Group T4-2.

T4-5-33 1 2 Check Port er Torque Convert Outlet Pressure Check Port er Accelerator Pedal Brake Pedal Travel Mode Clutch Cut-Off Position Switch Parking Brake Switch Fully Depressed Fully Depressed M OFF OFF