OPERATIONAL PERFORMANCE TEST / Component Test TRANSMISSION CLUTCH PRESSURE Summary: Measure each operating pressure of the tansmission clutch at each port of the transmission control valve. Preparation: 1. Stop the engine. 2. Remove the plug from the port. Install a hose, an adapter and a pressure gauge. Forward Clutch Pressure Reverse Clutch Pressure First Gear Clutch Pressure Second Gear Clutch Pressure Third Gear Clutch Pressure : 8 mm : 21 mm 3. Start the engine. Check for any oil leaks at the pressure gauge connection. 4. Maintain the torque converter oil temperature at 60 to 80 ° C (140 to 176 ° F). Measurement: Fourth Gear Clutch Pressure CAUTION:
Set the block onto the front and rear tires in order not to move machine. Keep away from the machine. 1. Select the following switch positions. T4GB-04-05-023 Accelerator Pedal Parking Brake Switch Fully Depressed OFF 2. Operate the forward/reverse lever and the shift switch. Measure each clutch pressure. 3. Repeat the measurement three times and calculate the average values. Evaluation: Refer to the Performance Standard Table in Group T4-2. T4-5-32 Brake Pedal Travel Mode Clutch Cut-Off Position Switch Fully Depressed M OFF F R 1st 2nd 3rd 4th Travel Switch Forward/Reverse Lever F R N N N N Shift Switch 4 4 1 2 3 4