OPERATIONAL PERFORMANCE TEST / Adjustment TRANSMISSION LEARNING After removing and/or replacing the components as described below for repair, perform the transmission learning (calibration). Replacement or repair of the transmission assembly, transmission control valve or clutch pack Replacement or repair of MC (Main Controller) Preparation: 1. Start the service mode in monitor. Start the engine. (Refer to T5-1-6.) 2. Select the transmission oil temperature on the monitor. (Refer to T5-1-7.) 3. Heat transmission oil. 3-1. Disconnect connector (1) (6-pole, gray) in the relay box from dummy connector. 3-2. Select or operate the switches from the left item in the table below.
Relay Box T4GB-04-06-007 1 T4GB-04-06-001 3-3. Stall the transmission and heat transmission oil to 90 ° C (194 ° F). 3-4. When transmission oil temperature on the monitor reaches 90 ° C (194 ° F), return the forward/reverse lever to neutral (N) and stop the engine. T4-6-1 Clutch Cut-Off Position Switch Shift Switch Parking Brake Switch Brake Pedal Accelerator pedal Forward/Reverse Lever OFF Second Gear OFF Fully Depressed Fully Depressed F