hitachi — Drive Belt Tension Adjustment

OPERATIONAL PERFORMANCE TEST / Adjustment DRIVE BELT TENSION ADJUSTMENT Summary: If the drive belt is loosened, the charge is defective of the battery or wear-out at early stage of drive belt occurs. If the drive belt is too tense, the water pump and the bearing of alternator are damaged. Adjust the drive belt within specification. Measurement: Push the drive belt between water pump (1) and alternator (2) pulley by finger. Measure slack of the drive belt. 1 Push Here Pushing force: Approx. 98 N (10 kgf, 72 lbf) CAUTION: As soon as the machine is operated, the engine is too hot. When measureing, take a good care. 2 Evaluation: Slack of drive belt: 6 to 8 mm (0.24 to 0.31 in) Adjustment: 1.

Loosen nut (3) and bolt (5). 2. Adjust tension of the drive belt to specification with bolt (4). 3. Tighten nut (3) and bolt (5). After tightening, check slack of the drive belt. M4GB-07-082 NOTE: When the drive belt is replaced with the new one, the drive belt does not fit first. After the engine is running at slow idle for 3 to 5 minutes, check slack of the drive belt. T4GB-04-03-001 T4-6-8 3 4 5 5 4