hitachi — How to Operate Service Made ofMonitor

TROUBLESHOOTING / Diagnosing Procedure HOW TO OPERATE SERVICE MODE OF MONITOR In case the engine starts in normal, the monitor is started in normal mode and only the items, which can be displayed in normal mode, are displayed on the liquid crystal display (LCD). (Refer to the next page.) When the monitor is started in service mode accord- ing to the following procedures, the items which can be displayed in normal mode, the fault code and one part of monitor items can be displayed. (Refer to the next page.) How to Start Monitor in Service Mode 1. Push the monitor display selector (up) and (down) in the monitor at the same time and the key switch is turned ON.

How to Used Monitor in Service Mode 1. Whenever pushing the monitor display selector (up) in the monitor, the display in information dis- play is changed. NOTE: The fault code is indicated in the display order 11. All fault codes can be indicated. In case more than one fault code is indi- cated, they will be displayed with an inter- val of 1 second in order. After the machine malfunction has been repaired, the fault codes are automatically deleted. Accord- ingly, if any trouble, which is not reproduci- ble, is encountered (this states are repeated that the trouble is resolved later altough the troubole sometimes occurs), it is recommended to use Dr.

ZX in order to check the fault code history. NOTE: The engine can start in normal. Information Display Liquid Crystal Display (LCD) T4GB-01-02-001 Monitor Display Selector (Down) Monitor Display Selector (Up) Mode Selection Switch T5-1-6