hitachi — Engine FailureMC Fault Code 11103

TROUBLESHOOTING / Troubleshooting A ENGINE FAILURE MC FAULT CODE 11103 Open circuit in harness between MC and accelerator pedal sensor (terminal #1). NO Disconnect connector MC-C in MC. Check for continuity between terminal #C13 of harness end of connector and terminal #1 of harness end of connector in accelerator pedal sensor. YES With connector of accelerator pedal sensor connected, insert a tester probe into rear of connector of terminal #1. Operate accelerator pedal. Check if voltage reaches specification. YES Faulty MC. Check if voltage between terminals #2 and #6 of harness end of connector in accelerator pedal sensor is 5 ± 0.5 V. YES Faulty accelerator pedal sensor.

Check if voltage between terminal #2 of harness end of connector in accelerator pedal sensor and vehicle frame is specigication. NO · Key switch: ON · Key switch: ON · Specification: Refer to the table below. YES Open circuit in harness between MC and accelerator pedal sensor (terminal #6). NO Open circuit in harness between MC and accelerator pedal sensor (terminal #2). Specification of Accelerator Pedal Sensor Connector (Harness end of connector viewed from the open end side) · Key switch: ON · Specification:

5 ± 0.5 V NO MC Connector MC-C #C13 Accelerator Pedal Sensor Connector C23 C31 #2 #1 4 8 #6 T5-5-75 Fault Code Trouble Cause Influenced Control 11103-3 Abnormal Accelerator Pedal High Voltage Voltage: 4.75 V or higher Pump Torque Decrease Control Engine Accelerator Pedal Control 11103-4 Abnormal Accelerator Pedal Low Voltage Voltage: Less than 0.25 V Pump Torque Decrease Control Engine Accelerator Pedal Control Slow Idle 0.5 to 0.65 V Fast Idle 4.35 to 4.5 V C1 C10 1 5