hitachi — Transmission FailureMC Fault Code 11600

TROUBLESHOOTING / Troubleshooting A TRANSMISSION FAILURE MC FAULT CODE 11600 Connector (Harness end of connector viewed from the open end side) Connect terminals #1 and #2 of harness end of connector in travel speed sensor by using a clip. Disconnect connector MC-C in MC. Check for continuity between terminals #C19 and #C7 of harness end of connector MC-C. YES Faulty MC. NO Connect terminal #C19 of harness end of connector MC-C in MC to vehicle frame. Check for continuity between terminal #2 of harness end of connector in travel speed sensor and vehicle frame. YES Open circuit in harness between MC and travel speed sensor (terminal #1). Replace travel speed sensor.

Turn key switch ON in 10 seconds after key switch is turned OFF. Retry. Check if fault code disappears. NO Open circuit in harness between MC and travel speed sensor (terminal #2). · NO · Key switch: ON Faulty travel speed sensor. YES MC Connector MC-C C1 #C19 #C7 C10 C23 C31 Travel Speed Sensor Connector #2 #1 T5-5-86 Fault Code Trouble Cause Influenced Control 11600-3 Abnormal Travel Speed Sensor The abnormal value below is detected with the clutch connected. • Travel speed sensor=0 min-1 • Middle shaft sensor>300 min-1 • Torque converter output speed sensor>500 min-1 • Detected voltage under the shorted circuit with key ON:

4.5 V or higher All Transmission Control 11600-4 Abnormal Low Voltage of Travel Speed Sensor Detected voltage under the shorted circuit with key ON: Less than 1.5 V All Transmission Control