TROUBLESHOOTING / Troubleshooting A · Key switch: ON · Key switch: OFF Connector MC Connector MC-C (Harness end) ECM Connector (Harness end) #C15 #C4 #18 #37 C1 C10 C23 C31 T1GR-05-04-002 ICF Connector ICF (Harness end) Monitor Unit Connector Monitor-2B (Harness end) #C5 T1V1-05-04-002 #C11 T4GB-05-05-002 #B34 #B33 T5-5-93 Connect connector in MC. B Check if fault code 11004-2 is displayed. Connect connector in MC. Check if fault code NO Check the connections of MC and connector. 11004-2 is displayed. Faulty MC. YES NO Check the connections of Connect connector ECM and connector. in MC. YES Check if fault code 11004-2 is displayed. Faulty ECM. YES · Key switch:
ON Connect connector NO Check the connection of C in ICF. ICF and connector. YES Check if fault code 11004-2 is Connect connector in displayed. Faulty ICF. ECM. YES Disconnect · Key switch: ON connector ICF-C in ICF. Check the connections of NO Check if resistance Connect connector monitor unit and NO between terminals Connect connector in YES in monitor unit. connector. #C5 and #C11 of ICF. Check if fault code harness end of Disconnect 11004-2 is Faulty monitor unit. connector is within connector monitor-2B displayed. 60±10 Ω. in monitor unit. · Key switch: ON YES · Key switch:
OFF Check if resistance NO between terminals #B33 and #B34 of harness end of Faulty in any controller in connector is within MC, ICF, ECM or monitor 120±10 Ω. NO unit. NO Check the connections of ECM and connector. Faulty in any controller in MC, ICF, ECM or monitor unit. Connect connector in MC. Check if fault code YES 11004-2 is displayed. Connect connector in ICF. Check if fault code YES 11004-2 is displayed. Connect connector in ECM. Disconnect connector ICF-C in ICF. Check if resistance NO between terminals #C5 and #C11 of harness end of connector is within 60±10 Ω. Connect connector in monitor unit. YES Check if fault code 11004-2 is displayed. NO Connect connector in ICF.
Disconnect connector monitor-2B in monitor unit. Check if resistance NO between terminals #B33 and #B34 of harness end of connector is within 120±10 Ω. Faulty monitor unit. YES