TROUBLESHOOTING / Troubleshooting A OTHER FAILURES MC FAULT CODE 11901 Connect terminals #1 and #2 of harness end of connector in hydraulic oil temperature sensor by using a clip. Disconnect connector MC-D from MC. Check for continuity between terminals #D8 and #D6 of harness end of connector MC-D. YES Faulty MC. Open circuit in harness between MC and hydraulic oil temperature sensor (terminal #1). Disconnect connector of hydraulic oil temperature sensor. Check if resistance at sensor end connector is specification. YES Connect terminal #D6 of harness end of connector MC-D in MC to vehicle frame.
Check for continuity between terminal #2 of harness end of connector in hydraulic oil temperature sensor and vehicle frame. YES NO Open circuit in harness between MC and hydraulic oil temperature sensor (terminal #2). NO · Specification: Refer to the table below. NO Faulty hydraulic oil temperature sensor. Specification of Hydraulic Oil Temperature Sensor Connector (Harness end of connector viewed from the open end side) NOTE: If fault code 11901-4 is not displayed and hydraulic oil temperature “-30 ° is displayed on the monitor by using Dr. ZX, the circuit in hydraulic oil temperature sensor may be opened.
MC Connector MC-D Hydraulic Oil Temperature Sensor Connector #D8 T183-05-04-009 #D6 T5-5-99 Fault Code Trouble Cause Influenced Control 11901-3 Hydraulic Oil Temperature Sensor High Voltage Voltage: 4.52 V or higher • Auto Warning-Up Control • Hydraulic Drive Fan Cooling Control 11901-4 Hydraulic Oil Temperature Sensor Low Voltage Voltage: Less than 0.23 V • Auto Warning-Up Control • Hydraulic Drive Fan Cooling Control Hydraulic Oil Temperature (°C, °F) Resistance (kΩ) -20, -4 16.2±1.6 0, 32 (5.88) 20, 68 2.45±0.24 40, 104 (1.14) 60, 140 (0.534) 80, 176 0.322 1 2