TROUBLESHOOTING / Troubleshooting B T5-6-10 Parts Function Symptoms in control system when trouble oc- curs. Symptoms in machine operation when trouble occurs. Transmission Middle Shaft Sensor • Sends the signal on trasmission middle shaft speed to MC. • MC cannot calculate travel speed. • If the travel speed sensor malfunctions, travel speed is not displayed on the monitor. Travel Speed Sensor • Sends the signal on trasmission output shaft speed to MC. • MC cannot calculate travel speed. • Auto gear shifting cannot be operated. Axle Oil Temperature Sensor • Is installed to the axle upper. • Sends the siganl on axle oil temperature to the monitor unit.
• Axle oil temperature cannot be detected. • Although axle oil temperature is over 120 °C, the service indicator does not light. • Altough axle oil temperature is less than 120°C, the service indicator lights. Service Brake Pressure Sensor • Is installed to the service brake pressure outlet port in front axle. • Sends the signal on pressure to MC. • MC makes clutch cut-off control disabled. • Although S, N or D in the clutch cut-off mode switch is selected, clutch cut-off is not operated when the brake pedal is depressed. Priority Valve (Main Pump) • Divides main pump delivery pressure oil into the steering valve and the control valve effectively.
• Division of main pump delievery pressure oil becomes less efficient. • The steering or front attahment is operated slowy according to malfunction. Main Pump Delivery Pressure Sensor • Sends the signal on main pump delivery pressure to MC. • Main pump delivery pressure cannot be detected. • MC makes torque decrease control disabled. • Although engine torque control cannot be operated properly, clear malfunction may not occur except bad fuel consumption. • As torque decrease control cannot be operated, the engine has a load during combined operation of travel and front attachment. Steering Relief Valve • Is installed to the priority valve (main pump) side on main pump upper.
• Is operated when steering circuit pressure exceeds the specification in order to protect the steering circuit. • If the valve is kept open, the priority valve (main pump) is operated abnormally. • If the valve is kept open, the priority valve (main pump) spool stops and pressure oil is supplied to the control valve. Then, steering is operated slowly. • If the valve is kept closed, the steering circuit may be damaged.