hitachi — Front Attachment SystemTroubleshooting

TROUBLESHOOTING / Troubleshooting B F-10 Bucket auto leveler is not operated. Check the wiring connections first. Connector (Harness end of connector viewed from the open end side) Connect terminal #2 of harness end con- nector in electro- magnet at bucket tilt side to vehicle frame. Operate bucket. While bar is located in front of proximity switch, check if there is continuity. Or while bar is away from proximity switch, check if there is discontinuity. YES Faulty electromagnet at bucket tilt side. Shorted or open circuit in harness between bucket proximity switch and electro- magnet at bucket tilt side, or open circuit in harness between bucket proximity switch and ground. · Engine:

Running · If one is YES, go to NO. Faulty bucket prox- imity switch. YES YES Disconnect connec- tor in bucket prox- imity switch. Check for continuity in same procedures as former ones. Check if results are same to former ones. Disconnect connector in electromagnet at bucket tilt side in pilot valve. Ground terminal #1 of harness end connector to vehicle frame. Check if voltage is 24 V. NO · Engine: Running NO · Engine: Running Faulty fuse or faulty harness between fuse box B and electro- magnet at bucket tilt side. NO Electromagnet Connector at Bucket Tilt Side #2 #1 T5-6-53 1 2