TROUBLESHOOTING / Troubleshooting B Disconnect abnor- mal connector in lift arm auto leveler switch. Ground terminal #2 of harness end of connector. Check if lift arm auto leveler is operated properly. A Open circuit in har- ness between lift arm auto leveler switch and MC. NO YES To C · Key switch: OFF Disconnect connector MC-D in MC. Check for continuity between terminal #D10 of harness end of connector and ter- minal #2 of harness end of connector in lift arm angle sensor. NO Open circuit in har- ness between MC and lift arm angle sensor. YES Check if voltage be- tween terminals #1 and #3 of harness end of connector in lift arm angle sensor is 5 ± 0.5 V.
YES To C B YES Open circuit in har- ness between MC and lift arm angle sensor (terminal #3). · Key switch: ON Check if voltage be- tween terminal #1 of harness end of con- nector in lift arm angle sensor and vehicle frame is 5 ± 0.5 V. NO Open circuit in har- ness between MC and lift arm angle sensor (terminal #1). · Key switch: ON NO Connect connector in lift arm solenoid valve in pilot valve. Connect terminal #2 of connector to vehicle frame. Turn lift arm raise lever to detent position. Check if lever is held. YES Open circuit in har- ness between lift arm electromagnet and MC, or faulty MC. YES Disconnect abnor- mal connector in lift arm solenoid valve in pilot valve.
Check if voltage at terminal #1 of harness end of connector is 24 V. Faulty lift arm elec- tromagnet. NO C Faulty fuse or faulty harness between fuse box B and lift arm solenoid valve. · Engine: Running NO T5-6-55 YES Faulty lift arm auto leveler switch. Connect terminal #2 of harness end of con- nector in lift arm auto leveler switch to vehi- cle frame. Disconnect connector MC-B in MC. Connect terminal #B20 NO (upward) or B3 (down- ward) of harness end to vehicle frame. Check for continuity.