hitachi — Travel System Troubleshooting

TROUBLESHOOTING / Troubleshooting B T-4 Even if travel speed is turned up or down, travel speed gear is not changed. If the travel speed sensor malfunctions or if two wirings in the shift switch are opened, travel speed is fixed to second gear. When the travel speed sensor malfunctions, the fault code is dis- played on MC. Check the wiring connections first. Refer to T2-1-28 to 31 in the Control System group/ SYSTEM section. Monitor travel speed gear SW of MC moni- tor item on Dr. ZX. Operate shift switch from first gear to fourth gear. Check if travel speed gear is displayed on screen according to switch operation. Refer to Troubleshooting A. YES NO YES Disconnect connector in shift switch.

Check if voltage at terminal #7 of harness end of connector is 24 V. Execute troubleshoot- ing of each controller by using Dr. ZX. Check if any fault codes are displayed. · Key switch: ON · Key switch: ON NO NO Faulty fuse or open circuit in harness. · Engine: Running Refer to Troubleshooting A. YES Connector (Harness end of connector viewed from the open end side) Connector MC-B Shift Switch Connector #B14 #B5 T183-05-04-021 #7 T5-6-64 1 2 3 4 5 6 7 8