hitachi — Travel System Troubleshooting

TROUBLESHOOTING / Troubleshooting B T-8 Travel mode is not shifted. Check the wiring connections first. Refer to T2-1-30 to 31 in the Control System group/ SYSTEM section. Monitor auto gear shift- ing mode of MC moni- tor item on Dr. ZX. Shift travel mode se- lector switch to auto L, N and H in this order. Check if Ld&Cry, Nor- mal and Power are dis- played on screen in this order. Refer to Troubleshooting A. YES NO Disconnect connector in travel mode selector switch. Check if voltages at terminals #2, #3, #4 and #5 of harness end of connector are 1V, 2V, 3V and 4V respec- tively. NO YES Normal. Execute troubleshoot- ing of each controller by using Dr. ZX.

Check if any fault codes are displayed. · Key switch: ON NO · Key switch: ON · Engine: Running Refer to Troubleshooting A. YES Connector (Harness end of connector viewed from the open end side) Travel Mode Selector Switch Connector Monitor Unit Connector 1-B #2 #3 #B28 #4 #5 #B31 #B30 #B29 T4GB-05-05-002 T5-6-72 1 2 3 4 5 6