TROUBLESHOOTING / Troubleshooting B BLEEDING AIR FROM BRAKE (AXLE) IMPORTANT: If air is contained in the brake, brake efficiency is low so that the serious accident may occur. When the brake pipe is installed/ removed or hy- draulic oil is replaced, release any pressure in the brake. Until hydrau- lic oil (0.5 L) comes out from each wheel (4 places) after bubbles stops, continue to release any pressure. 1 1 NOTE: Two or more workers should do this work at each wheel (4 places). Air bleed plug (1) is located near the center of front/ rear axle upper. 1. Turn the parking brake switch in front console to P. Start the engine. Increase service brake oil pres- sure. 2.
Attach clear vinyl tube (2) onto end of air bleed plug (1). Insert other of clear vinyl tube (2) into clear container (3) filled with hydraulic oil. 3. Depress brake pedal (4) several times. Then, de- press and hold brake pedal (4) to the stroke end. 4. Loosen air bleed plug (1) under condition in step 3 and drain hydraulic oil and air for several sec- onds. 5. Tighten air bleed plug (1). 6. Drain hydraulic oil after bubbles stops in steps 3 to 5 repeatedly. T4GB-05-04-004 2 1 3 T4GB-05-04-005 NOTE: When hydraulic oil (0.5 L) comes out, air may be remained. In this case, repeat steps 3 to 5. 7. Release any pressure at other 3 places in the same procedures as steps 3 to 5. IMPORTANT:
After air bleeding work is completed at 4 places, release any pressure at 4 places again. Release any pres- sure in the same procedures as steps 3 to 5 twice and check if no remained pressure inside. 4 T4GB-05-04-006 T5-6-111