TROUBLESHOOTING / Troubleshooting C TROUBLESHOOTING C (TROUBLE- SHOOTING FOR MONITOR) PROCEDURE Use troubleshooting C when any monitors, such as gauges or indicators malfunction. How to Read Troubleshooting Flow Charts After completing the checking and/or measuring procedures in box (1), select YES (OK) or NO (NOT OK) and proceed to box (2) or (3). Instructions, reference, and/or instruction methods on inspection and/or measurements are occasionally described under the box. If incorrectly checked or measured, not only will troubleshooting be unsuccessful but also damage to components may result. · Key switch:
ON Use the service mode in monitor and the diagnosing system / controller diagnosing system in Dr. ZX. Causes of machine problems are stated in the thick-line box. Scanning quickly through the thick-line boxes, allows you to estimate the possible causes before actually following the flow chart. NOTE: All harness end connector are seen from the open-end side. Harness End Connector Harness Open End Side T6L4-05-03-001 T5-7-1 YES (OK) (2) (1) (3) NO (NOT OK) YES (OK) (2) (3) NO (NOT OK)