TROUBLESHOOTING / Electrical System Inspection 5-V Circuit Voltage between terminal #1 and the vehicle frame With the key switch turned OFF, disconnect the connector. Measure voltage between the terminal of 5V power source on machine harness end connector and the vehicle frame (ground). Key switch: ON Tester black probe (negative): Vehicle frame (ground) Tester red probe (positive): Terminal of 5V power source Evaluation: If the measured voltage is within 5 ± 0.5 V, the circuit up to terminal of 5V power source is normal. IMPORTANT: Altough terminal #1 is the teminal of power source on the illustlation, all the terminals are not terminals of power source.
Before measurement, check the electrical circuit diagram for the connector to be measured. Voltage between terminal #1 and the ground terminal With the key switch turned OFF, disconnect the sensor connector. Measure voltage between the terminal of 5V power source on machine harness end connector and the ground terminal. 1 2 V T107-07-05-006 Key switch: ON Tester black probe: Ground terminal (terminal #2 or #3) Tester red probe: Terminal of 5V power source Evaluation: If the measured voltage is within 5 ± 0.5 V, the circuits up to terminal of 5V power source and ground terminal are normal. IMPORTANT:
Altough terminal #1 is the teminal of power source, terminal #2 is the signal and #3 is the ground terminal respectively on the illustlation, all the connectors are not arranged similarly. Before measurement, check the electrical circuit diagram for the connector to be measured. T107-07-05-009 T5-8-16 Power Signal or Two Polarities Power Source Source Ground Power T hree Polarities Source Signal Ground Power Source T107 Signal or -07-05-007 T wo Polarities Ground Power Signal Ground Power T hree Polarities Source