hitachi — Service Brake Pressure (Front and Rear)

OPERATIONAL PERFORMANCE TEST / Component Test SERVICE BRAKE PRESSURE (FRONT AND REAR) (The pressure can be measured by using Dr. ZX.) CAUTION: If air is mixed in the brake system, the brake function is reduced and serious hazard may occur. Bleed air from the brake system after removing and installing the pipe lines and replacing hydraulic oil. Refer to Troubleshooting B in Group T5-6. Summary: Measure the pressure at the brake valve pressure check port when the brake pedal is depressed. Preparation: CAUTION: Set the block onto the front and rear tires in order not to move the machine. Keep away from the machine. 1. Stop the engine. 2.

Push the air bleed valve on top of the hydraulic oil tank and release any remaining pressure. 3. Depress the brake at least 50 strokes in order to reduce the accumulated pressure left in the brake circuit. 4. Install the measuring devices to the front and rear wheel brake circuits. 4-1. Front wheel brake circuit pressure: Remove plug (1) from the pressure check port in brake valve. Install a nipple and a pressure gauge to the pressure check port. T4GB-04-05-017 Block : 19 mm, 22 mm : 6 mm 4-2. Rear wheel brake circuit pressure: Remove plug (2) from the pressure check port in brake valve. Install a nipple and a pressure gauge to the pressure check port. : 19 mm, 22 mm : 6 mm 5.

Start the engine. Check for any oil leaks at the pressure gauge connection. 6. Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). T4GB-04-05-018 T4-5-22 rake Valve 1 2 B rake Valve 1