OPERATIONAL PERFORMANCE TEST / Component Test T4-5-21 Adjustment Item Adjustment Procedure Remarks 2. Pilot Pressure Characteristics Q Pi Loosen lock nut (1) and turn adjusting screw (2). Rotate adjusting screw (2) 1/4 a turn clockwise and the pump flow rate decreases by X cm3/rev. (X in3/rev). ZW220: X=8.08 (0.49) ZW250: X=9.22 (0.56) : 17 mm : 20 N⋅m (2 kgf⋅m, 15 lbf⋅ft) 1) Do not turn the adjusting screw (2) more than one turn. 2) Securely tighten lock nut (1) after the adjustment. 3. P-Q Control (Torque Adjustment) Q A Pd Q B Pd A: Loosen lock nut (7) and turn adjusting screw (8). Rotating adjusting screw (8) 1/4 a turn clockwise increases and the pump flow rate increase by Y cm3/rev.
(Y in3/rev.). ZW220: Y=13.6 (0.83) ZW250: Y=15.5 (0.95) : 30 mm : 30 N⋅m (3.1 kgf⋅m, 22 lbf⋅ft) B: Loosen lock nut (9) and turn adjusting screw (10). Rotating adjusting screw (10) 1/4 a turn clockwise and the pump flow rate increases by Z cm3/rev. (Z in3/rev). ZW220: Z=3.9 (0.24) ZW250: Z=4.2 (0.26) : 13 mm : 10 N⋅m (1 kgf⋅m, 7.5 lbf⋅ft) 1) Do not turn the adjusting screws (8, 10) more than one turn. 2) Rotate the adjusting screws (8, 10) while watching the engine performance. 3) Securely tighten lock nuts (7, 9) after the adjustment.