Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 5 – Maintenance Procedures Page 5 - 3 CFP83 Series DAILY General Information Preventative maintenance begins with day-to-day awareness of the engine and its system. On a daily basis, inspect the engine for the following issues: Leaks Loose or damaged parts Worn or damaged belts Any change in engine appearance Odor of fuel Correct any problems as per the instructions in this manual. Perform the specific checks in this section only after the engine has been stopped. Do not perform this section if the fire pump is in operation. Engine Operation Report The engine must be maintained in top mechanical condition if the operator is to get optimum satisfaction from its use.

The maintenance department needs daily running reports from the operator to make necessary adjustments in the time allocated. The daily running report also helps to make provisions for more extensive maintenance work as the reports indicate the necessity. Comparison and intelligent interpretation of the daily report, along with a practical follow-up action, will eliminate most failures and emergency repairs. Report to the maintenance department any of the following conditions:

Low lubricating oil pressure Low power Power increases or engine surge Erratic or no accelerator control or response Any warning lights flashing or staying on Abnormal water or oil temperature Unusual engine noise Excessive smoke Excessive use of coolant, fuel, or lubricating oil Any fuel, coolant, or lubricating oil leaks Loose or damaged parts Worn or damaged belts Drawing No. 9777, Section 5, Rev. 02-07