Page 5 - 4 Section 5 – Maintenance Procedures CFP83 Series Unusual Engine Noise During daily maintenance checks, listen for any unusual engine noise that can indicate that service is required. Procedure 1 Check Air Intake Filter and Piping Visually inspect the air intake filter and piping daily for wear points and damage to piping, loose clamps, or punctures. Replace damaged air filter or pipes, and tighten loose clamps, as necessary, to prevent the air system from leaking. Refer to Adjustment, Repair and Replacement in Section 7 for replacement procedures. Check for corrosion under the clamps and hoses of the intake system piping.
Corrosion can allow corrosive products and dirt to enter the intake system. Disassemble and clean, as required. Refer to Adjustment, Repair and Replacement in Section 7 for replacement procedures. Torque loosened clamps. Torque Value: 8 N●m [72 in-lb] Procedure 2 Check Coolant Level WARNING Do not remove a pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap, (Cummins Fire Power Part No. 11407). Heated coolant spray or steam can cause personal injury. CAUTION Never use a sealing additive to stop leaks in the cooling system.
This can result in cooling system plugging and inadequate coolant flow, causing the engine to overheat. CAUTION Do not add cold coolant to a hot engine. Engine castings can be damaged. Allow the engine to cool to below 50°C [120°F] before adding coolant. Drawing No. 9777, Section 5, Rev. 02-07