Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 5 – Maintenance Procedures Page 5 - 9 CFP83 Series Inspect the charge air cooler for dirt and debris blocking the fins. Check for cracks, holes, or other damage. If damage is found, refer to Charge Air Cooler (CAC) Removal and Installation instructions in Section 7. Inspect the intake piping daily for wear points and damage to piping, loose clamps, or punctures that can damage the engine. Replace damaged pipes and tighten loose clamps as necessary to prevent the air system from leaking. Torque Value: 8 N•m [72 in-lb] Check for corrosion under the clamps and hoses of the intake system piping. Corrosion can allow corrosive products and dirt to enter the intake system.

Disassemble and clean as required. Procedure 7 Check Coolant Heat Exchanger Piping Visually inspect the coolant heat exchanger and piping daily for wear points and damage to piping, loose clamps, or punctures. Replace damaged tubes, clamps, or pipes, and tighten loose clamps, as necessary, to prevent the coolant system from leaking. Refer to Adjustment, Repair and Replacement in Section 7 for replacement procedures. Drawing No. 9777, Section 5, Rev. 02-07