Section 5 – Maintenance Procedures Page 5 - 11 CFP83 Series WEEKLY General Information With the engine not running, perform the daily maintenance checks plus the following: Procedure 9 Bleed Fuel Tanks Loosen the fuel tank drain plug or open the drain valve. Drain approximately 1 cup of fuel to remove water and sediment. Close the drain valve or tighten the drain plug. Dispose of the waste fuel in accordance with applicable requirements. Procedure 10 Clean Raw Water Strainers For each raw water strainer, remove the plug. Inspect and remove any debris. Install the strainer plugs. Unless otherwise directed, ensure that the bypass line valves are closed and the normal line valves are open.
Procedure 11 Check Battery Condition Inspect the condition of the batteries. Refer to Section 7 for inspection and maintenance procedures. Drawing No. 9777, Section 5, Rev. 02-07