Page 5 - 20 Section 5 – Maintenance Procedures CFP83 Series Remove Clean the area around the lubricating oil filter head. Using an oil filter wrench, remove the filter. Clean the gasket surface of the filter head with a clean lint-free cloth. NOTE : The o-ring can stick on the filter head. Make sure it is removed before installing the new filter. Install CAUTION The lubricating oil filter should be full of oil at start-up to prevent engine damage . Apply a light film of lubricating oil to the gasket sealing surface before installing the filters. Use clean 15W-40 oil to coat the gasket surface of the filter. Fill the filter with clean 15W-40 oil.
CAUTION Mechanical over tightening can distort the threads or damage the filter element seal. Install the filter on the oil filter head. Tighten the filter until the gasket contacts the filter head surface. Install the filter as specified by the filter manufacturer. Drawing No. 9777, Section 5, Rev. 02-07